• Home
  • Newtec Elevation Series EL478 High Speed IP Satellite Modem




Newtec Elevation Series EL478 High Speed IP Satellite Modem

(0) No Reviews yet
  • DVB-S2 compliant
  • XPE encapsulation
  • Data rates up to 160 Mbit/s
  • Noise & Distortion Estimator tool


SKU: SATRES-7964

Input/Output Interface
  • Auto switching 10/100/1000 Base-T Ethernet interface
  • Maximum rates: 160 Mbit/s in each direction, or 78,000 packets per second Tx + Rx
  • Layer 2 bridge mode: Ethernet frames over satellite
  • Layer 3 bridge or router mode: IP packets over satellite
  • Encapsulation: Extended Performance Encapsulation (XPE) -Newtec’s highly efficient IP encapsulation protocol for the encapsulation of IP frames in DVB-S2 base band frames
  • Filtering and routing capabilities (uplink)
    • Up to 32 VLANs filters
    • Up to 255 MAC filters
    • Up to 255 IP routes/air-MAC addresses
    • Up to 16 DVB-S2 Streams
  • Data filtering (downlink):
    • up to 32 streams in DVB-S2 Multi-stream
    • one air MAC address filter per stream
  • Proxy ARP support
  • Embedded point-to-point ACM controller (optional)
  • ACM client (optional)
Modulation and Demodulation
Supported modulation schemes and FEC
DVB-S2 Outer/Inner FEC: BCH/ LDPC
MODCODS: QPSK: 1/2, 3/5, 2/3, 3/4, 4/5, 5/6, 8/9, 9/10;

8PSK: 3/5, 2/3, 3/4, 5/6, 8/9, 9/10;

16APSK: 2/3, 3/4, 4/5, 5/6, 8/9, 9/10;

32APSK: 3/4, 4/5, 5/6, 8/9, 9/10
Baud rate range
DVB-S2 QPSK/8PSK/16APSK 0,256 - 45 Mbaud
32APSK 1 - 33 Mbaud
Frame length
DVB-S2 Normal Frames 64800 bits
Roll-off factor
20 % - 25 % - 35 %  
Modulator Interfaces
L-and output (default)
Connector SMA (F), 50 ohms
Level -50/-7 dBm (+/- 2dB)
Frequency 950 - 1750 MHz (50 Hz steps)
Return loss > 10 dB
IF-Band (optional)
Connector BNC (F) - 75 Ohm (intermateable with 50 ohms)
Level -30/+5 dBm (± 3 dB)
Frequency 50 - 180 MHz (50 Hz steps)
Return loss 50 ohms : > 14 dB

75 ohms : > 20 dB
L-Band monitoring output (default)
Connector SMA (F), 50 ohms
Level -45 dBm
Frequency 1080 MHz (fi xed frequency)
Return loss > 7 dB
BUC power and reference frequency (optional)
max. current 1.5 A
voltage 24V
frequency 10MHz
stability ±5x 10-8 over 0°C to 65°C
Spurious performance
better than - 65 dBc @ -10 dBm output level 
10 MHz reference input / output (optional)
ConnectorBNC (F) - 50 ohms
Input level -3dbm up to 7dBm
Output level+7dBm
Demodulator Interfaces
Dual L-band input (default)
Connector 2 x F-type (F), 75 Ohms
Level -65/-25dBm
Frequency 950 - 2150 MHz
Return loss > 7 dB (75 Ohm – F(F))
Adjacent signal < (Co+7) dBm/Hz with Co = signal level density
IF-band input (optional, replaces one L-band input)
Connector BNC (F) - 75 ohms
Level -55 to -15 dBm
Frequency 50 - 180 MHz
Return loss > 15 dB
Adjacent signal < (Co+7) dBm/Hz with Co = signal level density
LNB power and control
max. current 350 mA (on selected IFL input)
voltage 11,5 -14 V (Vertical polarization) 16 -19 V (Horizontal polarization) & additional 22 kHz +/- 4KHz (band selection according to universal LNB for Astra satellites & DiSEqC command transmission)
Generic
Monitor and control interfaces
  • Web server GUI (HTTP) via web browser
  • Diagnostics report, alarm log (HTTP)
  • RMCP over TCP-IP/UDP and RS232/RS485
  • SNMP v.2c/MIB
Alarm interface
  • Electrical dual contact closure alarm contacts
  • Connector 9-pin sub-D (F)
  • Logical interface and general device alarm
Physical
  • 1RU, width: 19”, depth 51 cm, 6 kg
  • Power supply: 90-130 & 180-260 Vac, 105 VA, 47-63 Hz
  • Temperature
    • Operational: 0°C to 40°C
    • Storage: -40 to +70°C
  • Humidity: 5% to 85% non-condensing
  • CE label

Ratings & Reviews

No reviews available

Be the first to Write a Review