Comtech EF Data High Power Outdoor SSPAs
- C-Band to 500W
- X-Band 200W
- Ku-Band to 200W
- Phase Combined Systems Available
High Power Outdoor Amplifiers (HPOD)
Comtech EF Data's High-Power Outdoor Solid-State Power Amplifiers provide a cost effective, more reliable replacement for TWT amplifiers in satellite communications terminals.
The Comtech HPOD in C, X or Ku-Band, delivers its rated power, guaranteed, at the 1 dB compression point, to the transmit waveguide flange.
Field Replaceable Power Supply
Recognizing that the MTBF limiting factor for almost all electronic equipment is the power supply, the HPOD provides for easy field replacement. Simply disconnect the AC mains, release the captive fasteners, and remove the supply from the SSPA module.
The Comtech HPOD Solid-State Advantage
Each HPOD SSPA is constructed with highly reliable GaAs FETs. With third order intermodulation products from 4 to 6 dB better than TWT ratings, the CEFD unit replaces TWTs with saturated power levels of up to twice the HPOD's rated output. The HPOD SSPA also provides an MTBF that is 4 to 5 times greater than the typical TWT MTBF.
An HPOD consists of an SSPA module with the Monitor/Control Processor (MCP), a field replaceable power supply, and a field replaceable fan assembly. The amplifier features a Comtech EF Data low loss combining technique and MCP-based temperature versus gain compensation.
Comtech EF Data's HPOD amplifiers were designed from the start to provide cost effective 1:1 or 1:2 systems. Redundant system control is built into the unit, eliminating an external controller with its associated cabling. This provides a cost benefit to our customer both at initial purchase and at installation.
Higher Power through Phase Combining
Comtech EF Data's phase-combined systems allow the outputs of two amplifiers to be summed together. A "normal" 1:1 system using 300W amplifiers provides 300W of output power (the offline unit's capabilities are unusable). The same amplifiers in a 1+1 phase-combined system will provide 600W of output power in normal operation, and a "soft failure" state of 300W. If no degradation on failure can be accommodated, a third amplifier can be added to form a 1:2 phasecombined system.
Optional "Smart BUC" Functionality
CEFD's unique approach to L band/RF frequency conversions eliminates DC and 10 MHz from the input coax. This greatly simplifies redundant and multicarrier operation. It offers full 13.75 to 14.5 GHz Ku coverage and supports industry standard FSK modem/BUC communications. The optional BUC can lock to an external or internal reference oscillator.
Comtech EF Data's HPOD SSPAs come equipped with useful features that other manufacturers offer as options. Included in each unit's base price are temperature compensation, sample ports, power monitor, field-replaceable power factor corrected supply, and full remote monitor and control capabilities.
|C-Band HPOD Specifications|
|Frequency||5.850 to 6.425 GHz|
5.850 to 6.725 GHz (Optional)
|Phase Combined Systems P1dB (Psat ), Watts||400(500)|
|Linear||70 dB min, 75 dB typical|
|Adjust||20 dB in 0,25 dB steps|
|Full Band||± 1.0 dB|
|Per 40 MHz||± 0.25 dB|
|-40 to +55°C||± 1.0 dB|
|Third Order Intermodulation|
|Products||-30 dBc typical, -25 dBc max @ 3 dB total back-off from rated P1dB (two tones, δf = 1 MHz)|
|AM to PM Conversion|
|2° typical, 3.5° maximum at rated output|
|Group Delay (per 40 MHz)|
|Ripple||±1.0 ns peak to peak|
|Second Harmonic||-60 dB dBc max @ 1 dB below rated output|
|Noise Figure||8 dB typical, 10 dB maximum @ maximum gain|
|Output Sample||Type N, 50O, -40 dBc nominal|
|Input Sample||Type N, 50O, -20 dBc nominal|
|Com Port||RS-485 or RS-232|
|Summary Fault||Form C|
|Operating Temp.||-40° to +55°C (-40° to 131°F)|
|Non-Operating Temp.||-50° to +75°C (-58° to 167°F)|
|Operating Humidity||0 to 100% condensing|
|Altitude||10,000 ft above sea level (derated 2°C/ 1000 ft AMSL)|
|180 to 264 VAC, 47 to 63 Hz|
|Dimensions (L x W x H)||26.77 x 17.88 x 11.49 inches|
(67.99 x 45.41 x 29.18 cm)
|Weight||75 lbs (34 kg) nominal|
|See Datasheet for X-Band and Ku-Band Specifications|